How do I apply the GLASSGUARD™ Glass Nanocoat KitUpdated 3 months ago

Make sure the area is well ventilated before use. We encourage you to wear a mask, gloves and goggles while applying the nanocoat.

• Ensure that the surface is clean and dry before application, including removing any stains, mould or mineral build up.
• Treat 1-3m² at a time and spray the nanocoat over the surface until it is evenly and completely covered. You should only require 2-3 sprays for this area.
• Wipe over the sprayed area using the supplied microfibre cloth, being sure to spread the product evenly over the entire surface.
• Continue to work the product into the surface in a circular motion until it is completely dry. This may take up to 30 seconds.
• For optimal effect, keep the area dry for the next 12-24 hours, while the product sets. This will ensure you get your full 5+ year protection.

IN CASE OF FAILED APPLICATION: If you have applied the Nanocoat incorrectly and notice 'grit', residue, or swirling marks, use a strong alcohol-based cleaner or methylated spirits (found at most hardware stores or supermarkets) to remove the Nanocoat. Afterward, you can reapply the Nanocoat by following the instructions above carefully.

 
WARNING: Do not ingest. Keep out of reach from children and pets. Avoid contact with eyes. If contact with eyes occurs, wash out thoroughly with water. If irritation persists, seek medical assistance.

https://glassguard.co.nz/products/diykit